[maker-devel] MAKER and RepeatModeler

[Carson Holt]

That is weird.

One thought though.  When you run MAKER do you supply both rmlib and model_org or just rmlib? If you are only supplying rmlib, you could try supplying both together (RepeatMasker will then run twice).  That way some of the edge cases might better be identified.

—Carson



> On Jul 16, 2015, at 5:25 PM, Shaun Jackman <sjackman at gmail.com> wrote:
> 
> Hi, Carson.
> 
> I removed two small contaminant contigs (~7 kbp) from the assembly (~6 Mbp), and MAKER found four fewer genes, four copies of the same atp8 gene, but these genes were not in the contaminant contigs.
> 
> I figured out that it’s because I’m running RepeatModeler to create the rmlib for MAKER. When I remove the contaminant contigs, RepeatModeler now identifies this gene atp8 as being a LTR/Gypsy repeat.
> 
> Any thoughts on why removing two contigs would cause RepeatModeler to identify new repeats?
> 
> Cheers,
> Shaun
> 
> 
> 
> 
> -- 
> http://sjackman.ca/ <http://sjackman.ca/>
> 
> _______________________________________________
> maker-devel mailing list
> maker-devel at box290.bluehost.com <mailto:maker-devel at box290.bluehost.com>
> http://box290.bluehost.com/mailman/listinfo/maker-devel_yandell-lab.org <http://box290.bluehost.com/mailman/listinfo/maker-devel_yandell-lab.org>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://yandell-lab.org/pipermail/maker-devel_yandell-lab.org/attachments/20150717/c3c791ca/attachment-0003.html>